Hei, onko kukaan saanut bank transferilla kotiutettua kirsikka kasinolta? Mulle nimittain tulee aika epamaaraisia vastauksia asiakaspalvelusta ja syita siihen miksi en voi kotiuttaa, vaikka pelasin bonuksen kotiutukseen tarvitun kierratysvaatimuksen verran. I don't know where the SDT/VCT (timeout) setting is set. If that works, you will need to repeat the settings for the other tuner.
that CAM is enabled, and decodable channels=1), and then try scanning using that tuner. You should see something like the following (I copied this from the Wiki):Ĭheck that the settings are as I described previously (i.e. The "Edit Tuner" panel that I see is for a DVB-T tuner, so its contents are slightly different from yours. This will enable the "Edit" button:įinally, click the "Edit" button. Notice that there is a greyed-out "Edit" button in the lower right corner. You should get a panel that looks similar to this: Expand your TV server (mine is called "Dell" yours is "Bob-PC").Expand the list of TV servers (left side menu).If this is the value in effect on your system, it might explain why all of the channels found are red.Ĭlick to expand.Sadly, the Wiki is not clear here (because the screen shots are not showing complete panels). The screen shot shows this value set to 0. Looking at the screen shots shown in the "Edit Tuner Settings" section of this page in the Wiki, you need to ensure that use of the CAM is enabled, and that the number of channels that can be decoded is set to 1. If enabled it will use your tuners pretty much continuously, which is unnecessary power use, wear and tear. This EPG grabber will not help you to get EPG. Untick the the two "enabled" checkboxes for the timeshifting/recording and idle EPG grabbers.Go to the "DVB EPG" section in TV Server configuration.You may need to increase this time if you find channels are missing or don't have proper names. Change the SDT/VCT setting to roughly 120 seconds.Go to the "scan" tab in the "general" section of TV Server configuration.
If all of the channels found are red, it may be that you have not configured MP to use the CAM. It found a total of 765 channels (which looks a believable number), and did not diagnose any errors. Click to expand.From reading mm's post in the thread I linked before, that outcome looks favourable.